| Vacuum tube or thermionic valve numbering systems |
Vacuum tube numbering systems
- for all types of thermionic valve or vacuum tube including the diode,
triode, tetrode, pentode, heptode, etc ...
In order that vacuum tubes or thermionic valve numbering had some reason to
it, numbering schemes were developed. Using these it was possible to gain an
approximate idea of the tube and its functions. There are two schemes that were
adopted, one used in Europe for valves primarily manufactured and used there,
and the other for vacuum tubes from the USA. Although the numbering schemes were
different, most valves or tubes were available with numbers in both systems.
Numbering systems
European System
| First letter indicates the heater supply |
Subsequent letters indicate the type of
valve |
Following figures indicate the base |
A 4V AC
C - 200mA AC and DC
D - Battery supply 1.2 to 1.4V
E - 6.3V AC and DC
G - 5V AC
K - 2V battery supply
P - 300 mA
U - 100 mA AC and DC |
A - Single diode
B - Double diode
C - Triode
D - Triode output valve
E - Tetrode
F - Pentode
H - Hexode or heptode
K - Octode
L - Pentode output valve
M - Tuning indicator
N - Thyratron
Q - Nonode
T - Miscellaneous
X - Gas filled full wave rectifier
Y - Half wave rectifier
Z - Full wave rectifier |
20 - 29 B8G (Loctal)
30 - 39 Octal
40 - 49 B8A
50 - 59 Miscellaneous constructions
60 - 79 Subminiature constructions
80 - 89 B9A
90 - 99 B7GIf a number is greater than a hundred then the first
figure should be disregarded to determine the base. |
American system
| First figure indicates the heater voltage |
Second and other characters are serial
numbers |
Suffix letters |
0 - Cold cathode
1 - 0 - 1.6V
5 - 4.6 - 5.6V
6 - 5.6 - 6.6V
7 - 6.3V Loctal
12 - 12.6V
35 - Around 35V |
|
G - Large glass envelope
GT - Small glass envelope
M - Metallised
X - Low loss base
W - Military type base |
|
